Oregon Scientific SE833 Manuel d'utilisateur télécharger pdf (Page 11)

REMOVE”.

4. Press

SET.

5. Press

ST/LAP/+ to select which device to delete.

6. Press

SET to conﬁrm selection.

CALIBRATING PAIRED DEVICE

The watch will not show “CAL DEVICE” if no device is

paired.

You can calibrate by running, walking or inputting parameter.

The parameter is the same value after you have successfully

calibrated by running or walking.

If you want to calibrate the device immediately after pairing,

go directly to step 4. Otherwise, start from the beginning.

CALIBRATE BY RUNNING OR WALKING

1. Press MODE repeatedly to select .

2. Press

SET.

3. Press

ST/LAP/+ repeatedly to select “CAL DEVICE”.

4. Press

SET.

5. Press

ST/LAP/+ to select “CAL BY RUN” or “CAL BY

WALK”.

6. Press

SET to conﬁrm selection.

7. The watch will conduct a device search ﬁrst, as

indicated by ﬂashing

and . Wait until stops

ﬂashing, then press SET to start calibration.

8. Ensure to complete walking or running the selected

distance for calibration.

Ø If calibration is successful, the watch will display

Run parameter

Walk parameter

NOTE The Run parameter and Walk parameter is the

value to enter when calibrating by inputting parameter.

Ø If calibration fails, the watch will display

NOTE The SZ909 chest belt should be calibrated both

by running and walking.

SE833 EN 11.indd 11 6/1/09 10:07:22 AM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

Commentaires sur ces manuels

Pas de commentaire

Oregon Scientific SE833 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Moniteurs de fréquence cardiaque Oregon Scientific SE833